For Expert Engineers , state the Reasons for such Kiln Damage ?? 8 Comments / HOME / By admin Previous Post Next PostTo download the below and all other Useful Books and calculations Excel sheets please click here To download the below and all other Useful Books and calculations Excel sheets please click here For Expert Engineers , state the Reasons for such Kiln Damage ?? Previous Post Next Post
Hitrndra Ruparel March 3, 2020 at 1:58 pmExcessive shell corrosion and kiln shell thickness very low no prevention measure taken. Reply
Apostolos Savvas March 3, 2020 at 11:05 pmHigh alcali,low refractory thickness,shell thickness,flame target low maybe. Reply
Puspdhar March 4, 2020 at 5:09 amIt may be due high alkali attack and not using anti-corrosive pain since long time Reply
Anonymous March 4, 2020 at 1:01 pmRapid bricks changing, alkali %high, floating in same position in running, over heating, Reply
Islam R El Sherif June 11, 2020 at 8:59 amBecause of high alkali attack, small thickness for refractories (no coating to preventing attak) because, they may be take long time to change bricks. Shell thickness small and easy to corrode. Production may be over kiln design. Reply
Islam R El Sherif June 11, 2020 at 9:04 amMay be mechanical problems supporting this problem like ovality, migration, alignment,…… Reply
Anonymous June 11, 2020 at 7:46 pmEn cas d’arrêt accidentelle avec un Présence d’un fissure et un problème de virage four au même temps . Reply
It is because of high alkali corrosion
Excessive shell corrosion and kiln shell thickness very low no prevention measure taken.
High alcali,low refractory thickness,shell thickness,flame target low maybe.
It may be due high alkali attack and not using anti-corrosive pain since long time
Rapid bricks changing, alkali %high, floating in same position in running, over heating,
Because of high alkali attack, small thickness for refractories (no coating to preventing attak) because, they may be take long time to change bricks. Shell thickness small and easy to corrode. Production may be over kiln design.
May be mechanical problems supporting this problem like ovality, migration, alignment,……
En cas d’arrêt accidentelle avec un Présence d’un fissure et un problème de virage four au même temps .